Often the condition of the paper or the way it's loaded can cause paper to get jammed. You will see the paper gliders both width & length slide them to the maxium. Gather the stack of paper you are trying to print on so you can look it over it. If you find any damage paper then toss it out. If you see any ripped, wrinkled and/or curled sheet of paper. Make sure that there are atleast ten sheets of plain white paper, However, keep it at a minimal of 25 sheets of paper in the copier stack. The copier can hold more sheets of paper, but this number is best for testing. Make sure all of the paper is the same size and type then tap it on a flat surface to get the edges perfectly align.
Lastly, load the paper in the input tray until it stops. Adjust the paper width guide until it stops at the edge of the paper. Do this for the paper length too. Do not push either guide in so tightly that it bends that paper. You can either print from the original document or press retry on the error message. Choose retry on the error message or attempt to reprint from the program on your PC. If the page prints successfully then the issue is solved. If the page does not print then continue on to the next step.
Next, we wil be certain that the paper settings in the copier match the settings. On your computer open a document from the scanner you are trying to print from. Select the file, then click print and then click properties, and if the properties dialogue box opens. Take a glance at the the paper/quality tab, find the size theres a drop down menu and choose the appropriate paper type, click OK & click okay again to print the document Your finish if the paper prints correctly. If not then go on to the next step.
Article Directory: http://www.articletrunk.com
Are you looking for finance a printer in miami or repair a scanner in fort lauderdale? Then give us a call 888-9591025
Please Rate this Article
Not yet Rated
Additional Articles From - Home
| Press Release Articles