How To Fit A Door Lock!

By: Barry Meat


We all know a door lock plays a big part in the security of a home. Your property would be safer if stronger and better quality door locks are used. Although most locks are easy to install, it can be a bit more difficult to select the best door lock for every specific door. Take into account the design, size and function of your door with a door lock’s specifications. For instance, a medium-sized door lock fitted on a substantial door will look awkward and may not serve its purpose of providing the maximum security in your home.

Installing a door lock is comparatively simple, that is, if you have the appropriate tools and you know very well what to do. But, before we go any further, you must first to pick the right door lock for the job by using these guide lines below:

Selecting the right door lock for the job:
1. Find out if the door is left or right handed. Stand outside the door and determine where the hinges are installed. The hinges are gong to be located on your right if you have a right-hand door, and the hinges will be on the left when you have a left-hand door. A number of door locks will fit in any of those arrangements but some will only fit with a particular door hanging. Left only or right only.

2. Measure the breadth of your door. With this information you can select a lock that will suit the width of the door. The majority of doors which are used in homes have a 1 3/8" thickness while most doors which are used in|used in} commercial establishments have 1 3/4".

3. Check the span between the centerline of your door knob bore hole and the border of your door – this is now called the backset of the door lock. If you are planning to fit a standard lockset, then the backset should normally be 2 3/8" or 2 ¾". However, some locks are designed to be adjustable and can fit varying backsets.

4. Select the right type of lock to fix on your door. Commercially available residential doors are typically ready for lock installation which means they already have holes drilled for locks. A bore hole with a diameter of 2 1/8" is intended for a cylinder lock but if you see a large pocket on the border of your door, it is designed to accept a mortise lock. However, if your door is customized you can choose whatever kind of lock you wish as long as it serves its purpose well.

Fitting the door lock:
1. Take out the lock template and attach it to the door. The new door lock should include a paper template which will illustrate how the lock is supposed to be fitted including the positions of your screws.

2. If your door doesn’t possess a pre-drilled hole for the lock, start drilling a hole according to the measurements shown on the paper template. At all times drill pilot holes for the screws too.

3. Position the lock in place. Carry out the instructions provided by the manufacturer to install the lock or, if you happen to have lost it, begin by fitting the latch through the wall of your door followed by the door knobs. Install and line up the connecting rods, and check whether the tail end of your cylinder is attached to the correct slot on the body of your lock. Fit the screws to secure the door lock in position.

4. If you don’t have an existing lock strike plate on the door frame, make room for one by using a chisel. Check the installation guide for instructions and measurements. Finally, fit the screws on the strike plate and try the lock see that it works.

Article Directory: http://www.articletrunk.com

| More

I have used many locksmith services through the years and they have never let me down yet. They are also cheaper than you might think. Locksmith Baham SW12 is the one that I use at the moment because that is the area that I live.

Please Rate this Article

 

Not yet Rated

Click the XML Icon Above to Receive Other A&E Articles Articles Via RSS!


Powered by Article Dashboard