Water fountains in indoor settings have become quite a buzzword among home decorators and owners like you in the last few years. This is not surprising, since indoor fountains give you a relaxed and peaceful atmosphere, as the water quietly runs in the fountain. Stores can attest to the popularity of indoor fountains. A look at stores in malls and on the Internet results in a lot of indoor fountains being sold. But what happens if you canít find your indoor fountain of your dreams in the malls or in the various websites? Do not fret. Actually, there are many of you that do not seem to find what they think are the right indoor fountains for them.
Having a beautiful and elegant indoor water fountain does not always have to be the same with what other people have just because you bought yours from a store or in the Internet. And, no, you donít want to pay for a fountain with an extremely steep price just to avoid having a commonly owned fountain. Try doing it on your own. The sound of the trickling water from a fountain you did might prove to be more peaceful and relaxing than the mass-produced ones.
I. Build Your Own Indoor Fountain
If you canít find an indoor fountain in the market that could match your personal taste, lifestyle, and uses, why not make your own? Making your own indoor fountain is cheaper than buying it in a store or online. Generally, making one would cost you around $40. There are a number of variations available in making your own water fountain, but the instructions in making one are very basic.
- for base, you could use a waterproof container
- aquarium pump that is submersible; easily available in garden centers or at fish stores
- copper pipe with diameter of half an inch
- easy-to-use pipe cutter that costs around $2.50 only
- silicone glue - when this dries up, the glue becomes clear
- two pieces of elbow joints
- reducer that goes on top of your pump
- a copper piece
- beautiful and appealing rocks which you will be using for your foundation to stabilize the fountain and make the foundation more sturdy
III. Building Steps:
1. Put the pump into your container
Since the pump hole is relatively smaller compared with copper fittings, you must add the reducer. By this time, you are prepared in putting the first arm of your copper foundation.
On the pipeís outer edge, put some silicone. Then put together the pieces one by one. Before putting the top pipe over it, you must have some holes pre-drilled. You can pre-drill using a drill bit with a one-eighth-inch size. This will make your fountain have the perfect flow. You must remember all the time that the copper frame size should fit snugly into your container, allowing the water to freely circulate.
2. Check if its top part is aligned
The top part is aligned if the water perfectly flows right into your container. Expect that the final arm will be longer since the pump will elevate it. Place the joint first, as this will make the arm secured. Measure then the pipe. Cut down the excess part.
3. Keep it stabilized
Adding a number of beautiful and large stones should make the weight heavier. After putting the large stones, put some small river pebbles. And then add water.
4. Go From There
Now you have the basic foundation for your indoor fountain! From there, you can design it based on your imagination, for the look of your fountain is limitless and depends on how imaginative and creative you can get. For just starters, you could improve your fountain look by putting dried flowers and grasses. Arrange them. If you plan on installing a fountain right inside your kitchen, you might want this example. You could create your base foundation using a used or old copper pan. Flatten it using a hammer. Then suspend the flatware using copper wire.
Article Directory: http://www.articletrunk.com
For more great indoor fountain related articles and resources check out fountains.water-garden-advisor.com
Please Rate this Article
Not yet Rated